JASET

SIMULATION OF TITANIUM ALLOY CUTTING PROCESS AND DETERMINATION OF CUTTING TOOL CONSUMPTION

Authors

  • Saydaxmedov Ravshan Xalxodjayevich

    Turin Polytechnic University in Tashkent, Mechanical and Aerospace Engineering Department, Doctor of Technical Sciences, Professor E-mail: saydakhmedov.ravshan@polito.uz ORCID ID: 0000-0002-3674-2423
    Author

  • Rusatmov Otabek Ro‘zimurod o‘g‘li

    Master's student of the "Aviation Engineering" Department, Faculty of Aviation Transport Engineering, Tashkent State Transport University in Tashkent, Tashkent, Uzbekistan
    Author

Keywords:

Titanium alloy, Ti-6Al-4V, cutting process, modeling, SimScale, cutting tool, tool eating, temperature area, cutting force, mechanical machining.

Abstract

In this thesis, the issues of modeling the mechanical machining process of titanium alloys as well as determining the wear of cutting tool are investigated. During the study, the cutting process of the Ti-6Al-4V titanium alloy was simulated in the SimScale program. As a result of modeling, it was determined that high temperatures and deformation are generated in the shear zone. Also with increased cutting speed, tool eating increased. Based on the results obtained, optimal processing modes have been recommended.

Downloads

Published

2026-06-05

Issue

Vol. 1 No. 9 (2026): CONFERENCE OF INNOVATIVE HORIZONS IN SCIENCE & ENGINERING

Section

Articles